User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
Contents
6 WiPort™ User Guide
SNMP Community Name _____________________________________________________ 57
Disable Telnet Setup ________________________________________________________ 57
Disable TFTP Firmware Upgrade ______________________________________________ 58
Disable Port 77FE (Hex) _____________________________________________________ 58
Disable Web Server _________________________________________________________ 58
Disable Web Setup__________________________________________________________ 58
Disable ECHO Ports_________________________________________________________ 58
Enable Enhanced Password __________________________________________________ 58
Disable Port 77F0 (Hex)______________________________________________________ 59
Factory Defaults_______________________________________________________ 59
Channel 1 Configuration _____________________________________________________ 59
Channel 2 Configuration _____________________________________________________ 59
WLAN Settings _____________________________________________________________ 60
Expert Settings _____________________________________________________________ 60
Security Settings ___________________________________________________________ 60
Email Settings _____________________________________________________________ 61
Exit Configuration Mode_________________________________________________ 61
6: Configurable Pins 62
Defaults Settings: ___________________________________________________________ 62
Features: _________________________________________________________________ 62
Control Protocol _______________________________________________________ 62
Guidelines ________________________________________________________________ 62
Commands ________________________________________________________________ 63
Examples ____________________________________________________________ 65
7: Monitor Mode 67
Entering Monitor Mode via the Serial Port ___________________________________ 67
Entering Monitor Mode via the Network Port _________________________________ 67
Monitor Mode Commands _______________________________________________ 67
8: Updating Firmware 69
Obtaining Firmware ____________________________________________________ 69
Reloading Firmware____________________________________________________ 69
Using TFTP: Graphical User Interface ___________________________________________ 69
Using TFTP: Command Line Interface___________________________________________ 70
Recovering the Firmware Using the Serial Port ____________________________________ 70
9: Troubleshooting 71
Diagnostic LED States __________________________________________________ 71
Problems and Error Messages ___________________________________________ 72
Technical Support _____________________________________________________ 75