User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
Configuration using Web-Manager
WiPortâ„¢ User Guide 35
Encryption Key
Field is enabled when WEP is selected as the Security type.
Enter the Encryption Key in hexadecimal value
Advanced Settings
Data Rate WiPort permits the control of the transmission rate. Select the
data rate (in Mbps) from the pull down menu.
Radio Power
Management
Power management reduces the overall power consumption
of the WiPort unit. Selecting Enable increases the response
time.
OEM Pin Configuration
There are 11 configurable hardware pins on the WiPort unit. For each pin, configure
the pin function, communication direction, and its activity level. For more information,
see Configurable Pins on page 62.
To configure the WiPort’s OEM Configurable Pins:
1. Click Configurable Pins from the main menu to open the Configurable Pins
window.
Figure 4-11. Configurable Pins Settings
2. Configure or modify the following fields for each pin:
Function From the pull down menu, select the purpose of the specified
pin. See Configurable Pin Functions for a description of each
available function.
Active Level Select the signal active level (Low or High).