User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
Configuration using Web-Manager
32 WiPortâ„¢ User Guide
Recipients
Recipient 1: Email
Address
Enter the email address designated to receive email
notifications.
Recipient 2: Email
Address
Enter an additional email address designated to receive email
notifications.
Trigger Configuration
A trigger event occurs when the unit receives the specified trigger input as a result of
a specified combination of conditions on the configurable pins.
Set the configurable pins to Active, Inactive, or None. The configurable pins are
disabled if they are all set to None. If both the serial sequence and the configurable
pins are disabled, the trigger is disabled.
To configure the WiPort’s email trigger settings:
1. From the main menu, select Trigger 1, Trigger 2, or Trigger 3 to configure the
desired Trigger settings. The Email Trigger Settings page opens.
Figure 4-9. Email Trigger Settings
2. Configure the following fields:
Conditions
Configurable Pins Select the condition from the pull down menu for the
configurable pins. Repeat for each Trigger Input field.
Enable Serial Trigger
Input
When selected, specified serial communications count as a
trigger input.