User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
Configuration using Web-Manager
WiPort™ User Guide 25
Figure 4-4. Hostlist Settings
2. Enter or modify the following fields from the Hostlist Settings window:
Retry Settings
Retry Counter Enter the value for the number of times the WiPort should
attempt to retry connecting to the host list.
Retry Timeout Enter the duration (in seconds) the WiPort should abandon
attempting a connection to the host list.
Host Information
Host Address
Enter or modify the host’s IP address.
Port
Enter the target port number.
Channel 1 and Channel 2 Configuration
Channel 1 and Channel 2 configurations define how the serial ports respond to
network and serial communication.
Serial Settings
To configure a channel’s serial settings:
1. From the main menu, click Serial Settings for either Channel 1 or Channel 2 to
display the Serial Settings page for the selected channel.