User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
Configuration using Web-Manager
24 WiPort™ User Guide
To configure the WiPort’s device server settings:
1. Click Server from the main menu.
2. Configure or modify the following fields:
Server Configuration
Telnet Password
Enter the password required for Telnet access.
Retype Password
Re-enter the password required for Telnet access.
Advanced
ARP Cache Timeout When the unit communicates with another device on the
network, it adds an entry into its ARP table. ARP Cache
timeout defines the number of seconds (1-600) before it
refreshes this table.
TCP Keepalive TCP Keepalive time defines how many seconds the unit waits
during an inactive connection before checking its status. If the
unit does not receive a response, it drops that connection.
Enter a value between 0 and 60 seconds. 0 disables
keepalive.
Monitor Mode @ Bootup
Select Disable to disable the entry into the monitor mode via
the 'yyy' or 'xx1' key sequence at startup. This command
prevents the unit from entering monitor mode by interpreting
the stream of characters that are received during the device
server's initialization at startup.
CPU Configuration Mode The WiPort provides a high-performance mode that supports
the baud rates 460 Kbps and 921 Kbps. When running the
serial port at 460 Kbps or 921Kbps, the CPU must be placed
in the high performance mode in order to keep the serial port
within this baud rate specification. The maximum serial speed
when not in high performance mode is 230 Kbps. The default
is Low.
HTTP Server Port This option allows the configuration of the web server port
number. The valid range is 1-65535. The default HTTP
server port number is 80.
Host List Configuration
The WiPort scrolls through the host list until it connects to a device listed in the host
list table. After a successful connection, the unit stops trying to connect to any others.
If this connection fails, the unit continues to scroll through the table until the next
successful connection.
The host list supports a minimum of 1 and a maximum of 12 entries. Each entry
contains an IP address and a port number.
Note: The host list is disabled for Manual and Modem Mode. The unit will not
accept a data connection from a remote device when the hostlist option is
enabled.
To configure the WiPort’s host list:
1. From the main menu, click the Hostlist tab.