User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
Configuration Using DeviceInstaller
WiPort™ User Guide 19
Match 2 Byte Sequence
Used with Match Byte 1 and Match Byte 2 to indicate the
end of a series of data to be sent as one group. The
sequence must occur sequentially to indicate to the WiPort
end of the data packet.
Send Frame Only After the detection of the byte sequence, indicates whether to
send the data frame or the entire buffer (i.e. include the trailing
bytes). Select True to send only the data frame.
Send Trailing Bytes Select the number of bytes to send after the end-of-sequence
characters.
7. To exit the Channel 1 and Channel 2 configurations, click OK.
Email Configuration
The unit sends an e-mail when a specific trigger event occurs. There are three
separate triggers, based on any combination of the configurable pins (PIO) when
selected as user I/O functions. Optionally, use a two-byte serial string to initiate a
trigger.
To configure the WiPort’s email settings:
1. From the Configure Device window for the WiPort unit, click the Advanced tab.
2. In the Email Notification section, enter the following fields:
Domain Name
Enter the Email server’s domain name.
Mail Server
Enter the IP address of the mail server.
Recipients
Click the “…” box to open the Email Recipient Collection
Editor window. Click on an entry in the Members section and
enter the email address in the Email Recipient Properties
window. Click OK when finished.
Triggers A trigger event occurs when the unit receives the specified
trigger input as a result of a specified combination of
conditions on the configurable pins.
Each trigger is independent of the others. Each condition
within an individual trigger must be met before the unit will
send the Email.
Click the “…” box to open the Email Trigger Collection Editor
window. Highlight a trigger in the Members section and
modify its properties in the Email Trigger Properties section.
Click OK when finished.
For more information on triggers, see Email Configuration on
page 53
Unit Name Enter the username used by the WiPort to send Email
messages.