User's Manual

21
Reforming a Version 1 Wireless Unit Battery
The reforming process for version 1 units involves a series of charges of progressively longer
duration. This process may take as long as 90 minutes, depending on the state of the battery.
1 Charge the battery by plugging the charging
adapter into the charger receptacle on the front of
the wireless unit (as shown).
Ensure the other end of the charging adapter is plugged
into an AC power outlet.
Charging is indicated by a blinking CHARGING LED.
2 When the CHARGING LED illuminates steady green, unplug the charging
adapter from the wireless unit and wait approximately 30 seconds.
If, during charging, the CHARGING LED blinked for an hour or more before
changing to steady green, the reformation process is complete. The wireless unit is
ready for use.
3 Repeat steps 1 and 2 six consecutive times.
■ NOTE: Upon completion, the wireless unit will have approximately 30 continuous
minutes or more of charge capacity and will be ready for normal use. Charge
capacity will continue to increase with subsequent normal usage and charging
cycles.
Reforming a Version 2 Wireless Unit Battery
The reforming process for version 2 units involves a series of 14 on/off cycles. The procedure
can be automated with the use of a timer. For optimal results start the procedure at 6 pm
and allow the unit(s) to charge overnight for the last (14th) cycle.
1 Set the unit(s) up for charging (see Figure 10 on page 22).
• Plug the charging adapter into the charger receptacle on the front of the wireless
unit(s).
• Plug the other end of the charging adapter into an AC power strip.
• Plug the power strip into the timer.
• Plug the timer into an AC power outlet.
• Plug one end of a phone cable into the wireless unit’s meter port.
• Plug the other end of the phone cable into the unit’s setup port.
charging
adapter
ethernet.book Page 21 Tuesday, December 11, 2007 11:25 AM