User's Manual

19
• Remote IP address = address of OneTouch
®
MeterLink™
• Remote Port = 3001
• DisConnMode = 00
• FlushMode = 00
• DisConnTime = 00:60
• SendChar1 & SendChar2 = 00
4 Select option 4—WLAN to configure your institution’s wireless network’s
parameters.
■ NOTE: Because each institution’s settings are unique, consult with your network
administrator to find the appropriate settings for the following parameters:
Topology, Network name, Security Suite, Encryption, and Data Rate.
5 Select option 9 and press Enter.
◆ IMPORTANT: Ensure step 5 is completed or changes will not be saved.
6 Unplug the cable from the setup port when you are finished.
Charging the Wireless Unit
Charge the battery before using the unit for the first time, when the LOW BATT LED
illuminates steady red, and after replacing the battery (version 2 only). Although you can
continue to use the unit when the LOW BATT LED is on, a successful data transfer session
may not be possible. Perform the charge at 0–30°C in a well ventilated room. If charging
multiple units, do not stack. Allow 2 inches between units.
To optimize the battery life, use the wireless unit until the LOW BATT LED illuminates
steady red. Do not leave the unit completely drained of battery power for longer than
1 month. Doing so may require reforming of the battery.
▲ CAUTION: Use only the charger provided by LifeScan. Note that version 1 and version
2 units require their own unique chargers.
Version 1 of wireless unit and charging adapter. Version 2 of wireless unit and charging adapter.
ethernet.book Page 19 Tuesday, December 11, 2007 11:25 AM