User's Manual
Table Of Contents
- Table of Contents
- OneTouch® DataLink® Connection Overview
- OneTouch® DataLink® Sync Configuration
- Modem-to-Modem Configuration
- Serial Server/Client-to-Ethernet Configuration
- Serial Server/Client-to-Ethernet Configuration Using Modems
- Terminal Server-to-Ethernet Configuration Using Multiple Receiving Modems
- Connecting to the Workstation
- Wireless Communication
- Establishing Connectivity Using OneTouch® MeterLink™ Software
- Transferring Data
- Troubleshooting
- Specifications
- Glossary
- Index
17
Setting Up the Wireless Unit
You must set up and configure the wireless unit before using it to transfer data. Units can
be configured from any computer. Charge the wireless unit before setting it up.
1 Connect a phone cable to the serial port connector. Then, connect the serial
port connector to the workstation’s serial port.
2 Open a HyperTerminal session in Windows.
3 Click Restore Defaults on the Port Settings screen. The COM properties for the
port should be:
• Bits Per Second = 9600
• Data Bits = 8
• Parity = None
• Stop Bits = 1
• Flow Control = None
4 Connect the charger to the wireless unit. Then, plug the charger into an
AC power outlet.
5 While holding down the X key on the keyboard (ensure Caps Lock is off),
connect the other end of the phone cable (from step 1) to the Setup jack on the
side of the wireless unit.
6 Press Enter when prompted.
Figure 9 Setting up the OneTouch
®
DataLink
®
Wireless unit
Configuring Network Parameters and Channel Settings
Perform the following steps with the wireless unit still connected to the computer.
1 From the Change Setup menu, select option 0 and press Enter.
2 Continue with the appropriate instructions below depending on whether you
are using static IP addresses or DHCP.
ethernet.book Page 17 Tuesday, December 11, 2007 11:25 AM