User's Manual

16
Wireless Communication
The OneTouch
®
DataLink
®
Wireless unit allows you to
transfer data from a OneTouch
®
Flexx™ meter to the
workstation via a network enabled through wireless
access. The meter plugs into a wireless unit located in the
meter tote. Data is transmitted through access points
installed on the network.
There are two versions of the wireless unit. The LifeScan
part number for the version 1 unit is 02130201. The
LifeScan part number for the version 2 unit is 02130202. The version 2 unit can be easily
identified by its battery door. Version 1 units do not have a battery door.
▲ WARNING: Never immerse the battery, dispose of it in a fire, store it in direct sunlight,
or attempt to disassemble it. Nickel Metal Hydride (NiMH) batteries
contain a strong alkaline fluid that is extremely corrosive and will cause
skin damage. If the battery leaks, properly dispose of it immediately. If the
fluid gets in your eyes, flush them with copious amounts of water and seek
medical attention.
The following table provides a description of the LEDs found on the wireless unit.
■
NOTE: If you need to reload the wireless unit’s firmware, or in the event of an upgrade,
LifeScan will assist you with obtaining the correct version, as well as installation
instructions.
LED Status Meaning
LOW BATT (red)
steady approximately 10% of battery capacity remaining (~20 minutes)
off sufficiently charged
blinking hardware error detected, see error table on page 37
CHARGING (green)
steady fast charge is complete (continues with trickle charge)
blinking unit is fast charging
WIRELESS (yellow)
steady wireless connection established
blinking searching for wireless connection
ACTIVITY (green)
steady active TCP (OneTouch
®
MeterLink™) connection
off
no TCP (OneTouch
®
MeterLink™) connection
blinking software error detected, see error table on page 37
OneTouch
®
DataLink
®
Wireless unit
ethernet.book Page 16 Tuesday, December 11, 2007 11:25 AM