User's Manual

30
1 Place the meter into the connection
module cradle.
The connection module turns on the meter.
• If you have an Ethernet configuration, data
is automatically transferred to the
workstation through the network.
• If a modem is detected, the connection
module automatically dials the receiving
modem (provided the number was
downloaded to the meter from the
workstation, or entered at the meter).
If the line is busy, the connection module
retries up to 20 times at 30-second
intervals before it times out.
If the receiving modem phone number was
not downloaded to the meter from the
workstation, the Enter Phone # screen
appears.
Enter the phone number for the receiving
modem, then press Ok.
Messages appear on the screen indicating the
status of the transfer. The meter beeps and a
message appears when data transfer is
complete.
2 Remove the meter from the connection module cradle and press Cont.
If the meter is off when you remove it from the connection module, you can verify that
the transfer was successful by turning on the meter. If an error occurred during the
transfer, the following message appears after the status screen: Last Data Transfer mm/
dd/yy hh:mm Failed. Additionally, the status of the last upload appears at the status
screen.
connection module and cradle
1
2
3
4
5
6
78
9
0
CLR
DEL
Enter Phone #
WAIT
ethernet.book Page 30 Friday, October 26, 2007 1:08 PM