User's Manual

27
3 Place the bedside unit in the connection
module.
• If you have an Ethernet configuration, data is
automatically transferred to the workstation
through the network.
• If a modem is detected, the connection
module automatically dials the receiving
modem (provided the number was
downloaded to the bedside unit from the
workstation, or entered at the bedside unit).
If the line is busy, the connection module
will retry up to 20 times at 30-second intervals before it times out.
■ NOTE: If you are sharing the modem with a fax machine, do not start a data transfer
session if a fax is being sent or received—the two cannot occur simultaneously.
If the receiving modem phone number was not
downloaded to the bedside unit from the
workstation, the Enter Phone # screen appears.
Enter the phone number for the receiving
modem, then press Dial.
Messages appear on the screen indicating the
status of the connection.
The indicator light on the connection module
blinks during the transfer of data. A message
appears when data transfer is complete.
4 Remove the bedside unit from the
connection module cradle and press Cont.
■
NOTE: If the bedside unit is off when you remove it from the connection module, you
can verify that the transfer was successful by turning on the bedside unit. If an
error occurred during transfer, the following message appears after the status
screen: Last Data Transfer mm/dd/yy hh:mm Failed. Additionally, the bedside unit
displays the date and time of the last successful upload at the Main Menu.
<
Appears for modem
transfer only.
ethernet.book Page 27 Friday, December 2, 2005 4:28 PM