User's Manual

Configuration via Serial Mode or Telnet Port
WiPort™ User Guide 61
Enable Encryption
Enable Encryption (Y) ? _
Key length in bits (256): _
Change Key (N) ? _
Enter Key: _
The Enable Encryption option displays if the WiPort model features AES encryption.
It enables AES encryption for tunneling only.
Valid options for the Key length in bits are 128, 192 and 256 bits
Select Change Key to modify the current AES encryption key. The default is (N) No.
If Change Key was selected, enter the key (at the Enter Key prompt) in hexadecimal
numbers. Enter 32 characters for 128 bits key length, 48 characters for 192 bits key
length, or 64 characters for 256 bits key length.
Enable Enhanced Password
Setting enhanced password allows an extended security password of 16-characters
for protecting Telnet access. N (No) is the default, which permits a 4-character
password protecting Setup Mode by means of Telnet and web pages.
Enable Enhanced Password (Y) ? _
Disable Port 77F0 (Hex)
Port 77F0 allows a custom application to query or set the eleven WiPort configurable
pins when they are functioning as general purpose I/O (GPIO). Disable this
capability, if desired, for security purposes.
Disable Port 77F0h ? _
The default setting, the N (No) option, enables GPIO control. The Y (Yes) option
disables the GPIO control interface.
Default Settings
Select 7 Default Settings from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, E-mail settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, and netmask remain unchanged. The configurable pins’ settings also
remain unchanged. The specific settings this option changes are listed below:
Channel 1 Configuration
Baudrate
9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C, no flow
control)
Port No
10001
Connect Mode C0 (always accept incoming connection; no active
connection startup)