User's Manual

Configuration Using Web-Manager
WiPort™ User Guide 27
Figure 4-7. UDP Connection Settings
Datagram Mode
Datagram Type Configures remote IP or network broadcast address and the
remote port. Enter 01 for directed or broadcast UDP.
Accept Incoming Select Yes to accept incoming UDP datagrams.
Endpoint Configuration
Local Port
Enter the local port number.
Remote Port
Enter the port number of the remote device.
Remote Host
Enter the IP address of the remote device.
Change Address Table
Field enabled when Datagram Type is set to FD. Enter values
between 1-255 to identify units on the local network of device
servers.
Email Configuration
The unit sends an Email to multiple recipients when a specific trigger event occurs.
There are three separate triggers, based on any combination of the configurable pins
when selected as user I/O functions. Optionally, use a two-byte serial string to initiate