UBox USB Device Server User Guide UBX4100
Table Of Contents
- Contents
- Using This Guide
- Introduction
- Installing the UBox
- Using USB Devices on the Network
- Changing the UBox's Settings
- Overview
- Viewing UBox Settings
- Editing Server Settings: Access Tab
- Editing Server Settings: Network Tab
- Editing Server Settings: USB Device Configuration Tab
- Applying, Canceling, or Removing Server Settings
- Restoring Default Settings
- Updating the UBox's Firmware
- Overriding Server Network Settings
- Refreshing Data
- Changing Local Software Settings
- Troubleshooting
- Status Light Behavior
- Configuring the Windows XP Firewall
- Compliance
- Lantronix Software License Agreement
- Lantronix Warranty
Changing Local Software Settings
Switching Between Sets of UBoxes
The UBox software on your computer can only “see” eight UBoxes at a time. This is
true even with Active Discovery, which can see UBoxes with different UDP port
numbers.
To use a ninth UBox, you have two options:
Change both the local UDP port and the UBox UDP port to the same new
port number so your computer can see the UBox. This forces the UBox
software to see only the UBoxes on the new UDP port; it will not see UBoxes
with a different UDP port.
Remove UBoxes with Yes in the Active Discovery column in the Server
Access Settings area of the Local Settings tab. This removes or prevents
UBoxes that are on another network from showing up on this computer.
UBox User Guide 48