Owners manual

6: Basic Parameters
SLC™ Console Manager User Guide 59
Figure 6-7 Routing Page
2. Enter the following fields.
3. Click the Apply button.
To view the IP Routing Table:
1. Click the IP Routes Report link. Figure 6-8 shows the page that displays.
Enable RIP Select to enable Dynamic Routing Information Protocol (RIP) to assign routes
automatically. Disabled by default.
RIP Version Select the RIP version. The default is 2.
Enable Static
Routing
Select to assign the routes manually. The system administrator usually provides the
routes. Disabled by default.
 To add a static route, enter the IP Address, Subnet Mask, and Gateway for the
route and click the Add/Edit Route button. The route displays in the Static
Routes table. You can add up to 64 static routes.
 To edit a static route, select the radio button to the right of the route, change the
IP Address, Subnet Mask, and Gateway fields as desired, and click the Add/
Edit Route button.
 To delete a static route, select the radio button to the right of the route and click
the Delete Route button.