Owners manual

6: Basic Parameters
SLC™ Console Manager User Guide 55
Figure 6-4 Adding Network IP Filter Rulesets
2. Enter the Ruleset Name. The Ruleset Name identifies a filter. The name can be letters,
numbers, and hyphens only but cannot start with a hyphen. For example, FILTER-2.
3. Enter following fields.
Rule Parameters
IP Address Specify a single IP address to act as a filter.
Example: 172.19.220.64 – this specific IP address only
Subnet Mask Specify a subnet mask to act as a filter.
Example: 255.255.0.0
Protocol Select from the drop-down list the type of protocol through which the filter will
operate. The default setting is All.
Port Range Enter a range of destination TCP or UDP port numbers to be tested. An entry is
required for TCP, TCP New, TCP Established, and UDP, and is not allowed for
other protocols. Separate multiple ports with commas. Separate ranges of ports by
colons.
Examples:
22 – filter on port 22 only
23,64,80 – filter on ports 23, 64 and 80
23:64,80,143:150 – filter on ports 23 through 64, port 80 and ports 143 through 150