Owners manual

6: Basic Parameters
SLC™ Console Manager User Guide 54
Figure 6-3 IP Filter Page
1. Enter the following fields.
2. Click the Apply button.
Note: You cannot enable or disable individual filters.
Configuring IP Filters Rulesets
The administrator can add, edit, delete, and map IP filter rulesets.
Note: A configured filter ruleset has no effect until it is mapped to a network interface.
See To map a ruleset: on page 56
To add an IP filter ruleset:
1. On the IP Filter page, click the Add Ruleset button. Figure 6-4 shows the page that displays.
Enable IP Filter Select the Enable IP Filter checkbox to enable all filters, or clear the
checkbox to disable all filters. Disabled by default.
Packets Dropped
(view only)
Displays the number of data packets that the filter ignored (did not respond
to).
Packets Rejected
(view only)
Displays the number of data packets that the filter sent a “rejected” response
to.
Test Timer Timer for testing IP Filter rulesets. Select No to disable the timer. Select Yes,
minutes (1-120) to enable the timer and enter the number of minutes the
timer should run. The timer automatically disables the IP Filters when the
time expires.
Time Remaining
(view only)
Indicates how many minutes are left on the timer before it expires and IP
Filters are disabled.