Owners manual

SLC™ Console Manager User Guide 47
6: Basic Parameters
This chapter describes how to set the following basic configuration settings for the SLC console
manager using the SLC web interface or CLI:
 Network parameters that determine how the SLC console manager interacts with the attached
network
 Firewall and routing
 Date and time
Note: If you entered some of these settings using a Quick Setup procedure, you may
update them here.
This chapter contains the following sections:
 Requirements for IP Address Assignment
 Network Settings
 IP Filters
 Routing
Note: The features and functionality described in this chapter specific to PC Card use
are supported on SLC -02 part numbers. The features and functionality specific to USB
port use are supported on SLC -03 part numbers.
Requirements for IP Address Assignment
If you assign a different IP address from the current one, it must be within a valid range, unique to
your network, and with the same subnet mask as your workstation.
To configure the unit, you need the following information:
Eth1
IP address: ________. ________ . ________ .________
Subnet mask: ________. ________ . ________ .________
Eth2
IP address (optional): ________. ________ . ________ .________
Subnet mask (optional): ________. ________ . ________ .________
Gateway: ________. ________ . ________ .________
DNS: ________. ________ . ________ .________