Owners manual

15: Command Reference
SLC™ Console Manager User Guide 227
Description
Displays the modes and states of one or more device port(s). You can optionally email the
displayed information.
Diagnostic Commands
diag arp
Syntax
diag arp [email <Email Address>]
Description
Displays the ARP table of IP address-to-hardware address mapping. You can optionally email the
displayed information.
diag internals
Syntax
diag internals
Description
Displays information on the internal memory, storage and processes of the SLC console manager.
diag lookup
Syntax
diag lookup <Name> [email <Email Address>]
Description
Resolves a host name into an IP address. You can optionally email the displayed information.
diag loopback
Syntax
diag loopback <Device Port Number or Name>[<parameters>]
Parameters
test <internal|external>
xferdatasize <Size In Kbytes to Transfer> (Default is 1 Kbyte.)
Description
Tests a device port by transmitting data out the port and verifying that it is received correctly. A
special loopback cable comes with the SLC console manager. To test a device port, plug the cable
into the device port and run this command. The command sends the specified Kbytes to the
device port and reports success or failure. The test is performed at 9600 baud. Only an external
test requires a loopback cable.