Owners manual

SLC™ Console Manager User Guide 203
15: Command Reference
This chapter lists and describes all of the commands available on the SLC command line interface
(CLI) accessed by using Telnet, SSH, or a serial connection. In addition to the commands, this
chapter contains the following sections:
 Introduction to Commands
 Deprecated Commands
The following is an alphabetical listing of categories and within each category there is a list of
commands in alphabetical order:
Introduction to Commands
This section explains command syntax, command line help, and tips for using commands. For
more detailed information about commands, see Command Line Interface on page 42.
Command Syntax
Commands have the following syntax: <action> <category> <parameters>. The <action> value
can be one of the following: set, show, connect, diag, pccard, admin, or logout. The <category>
value is a group of related parameters that you can configure or view. Examples are ntp,
deviceport, and network.
The <parameters> value is one or more name-value pairs in one of the following formats:
 <aa | bb> User must specify one of the values (aa or bb) separated by a vertical line (|). The
values are in all lowercase and must be entered exactly as shown. Bold indicates
a default value.
 Administrative Commands  Log Commands
 Audit Log Commands  Network Commands
 Authentication Commands  NFS and SMB/CIFS Commands
 CLI Commands  NIS Commands
 Connection Commands  PC Card Commands
 Console Port Commands  RADIUS Commands
 Custom User Menu Commands  Remote Users Commands
 Date and Time Commands  Routing Commands
 Device Commands  Script Commands
 Device Port Commands  Services Commands
 Diagnostic Commands  SLC Network Commands
 Email Log Commands  SSH Key Commands
 Events Commands  Status Commands
 Host List Commands  System Log Commands
 IP Filter Commands  TACACS+ Commands
 Kerberos Commands  Temperature Commands
 LDAP Commands  USB Commands
 Local Users Commands  User Permissions Commands