Owners manual
9: PC Cards
SLC™ Console Manager User Guide 123
Data Settings
ISDN Settings
Note: These fields are disabled if the PC Card inserted is not an ISDN card.
GSM/GPRS Settings
These settings are only active when a GSM/GPRS PC card modem is in the appropriate slot.
Notes:
Please consult your wireless carrier configuration requirements for more detailed
information.
Dial-out GPRS connections may replace the default route and DNS entries. Static
routes may be required to maintain access to subnets that are not directly attached to
the SLC console manager. Click the Static Routes link (above Data Settings) to
configure a static route. (See Routing on page 58.)
Dial-back Delay For dial-back and CBCP Server, the number of seconds between the dial-in and
dial-out portions of the dialing sequence. For more information about CBCP, see
Modem State Parameters on page 277.
Baud The speed with which the device port exchanges data with the attached serial
device.
From the drop-down list, select the baud rate. Most devices use 9600 for the
administration port, so this is the default. Check the equipment settings and
documentation for the proper baud rate.
Data Bits Number of data bits used to transmit a character. From the drop-down list, select
the number of data bits. The default is 8 data bits.
Parity Parity checking is a rudimentary method of detecting simple, single-bit errors.
From the drop-down list, select the parity. The default is none.
Stop Bits The number of stop bit(s) used to indicate that a byte of data has been transmitted.
From the drop-down list, select the number of stop bits. The default is 1.
Flow Control A method of preventing buffer overflow and loss of data. The available methods
include none, xon/xoff (software), and RTS/CTS (hardware). The default is none.
Channel Select to indicate which B channel on the ISDN card to use. Valid values are 1 and
2. (The B-channel is the channel that carries the main data.) Only one 64K
channel can be used at a time.
Phone Number Phone number associated with the B channel. May have up to 20 characters. Any
format is acceptable.
Dial-out Mode Select the type of dial-out connection:
GPRS: (General Packet Radio Service)
GSM: (Global System for Mobile communication)
PIN
Retype PIN
PIN (personal identification number) for accessing the GSM/GPRS card.