Manualshelf

Owners manual

ManualsBrandsLantronix ManualsComputers & LaptopsSGX 5150 Wireless IoT Gateway, 802.11a/b/g/n/ac, 2xRS232 (RJ45), USB, 10/100 Ethernet, US Model - Twisted Pair - 1 x N
919293949596979899100
9: Administration
SGX 5150 IoT Device Gateway User Guide 95
USB Configuration
This page displays the current configuration of the USB Line. Changing any of the fields takes
effect immediately. Further configuration is available at Wired Network (USB) for 'Ethernet Device'
mode.
Table 9-25 USB Configuration
To Configure USB Settings
Using Web Manager
To configure usb settings, on the Administration page, click USB > Configuration.
Using the CLI
To enter the usb command level: enable > usb
Using XML
Include in your file: <configgroup name="usb">
USB Serial Command Mode
Table 9-26 USB Command Mode
USB Settings Description
Name
Enter the Name of the usb line. Named lines appear in the 'Login Connect
Menu', if enabled. Set it blank to leave it out of the menu.
Interface Select the Interface from the drop-down menu.
State Select to enable or disable the State.
Protocol Select type of Protocol from the drop-down menu: Tunnel or None.
Line Mode Select the USB port mode from the drop-down menu. The USB port can be
configured in one of the following: Ethernet Device, Serial Device, or Host. Host
mode supports connecting Mass Storage and Serial devices.
Gap Timer Indicate the gap time in milliseconds. The driver forwards received serial bytes after
the Gap Timer delay from the last character received. By default, the delay is four
character periods at the current baud rate (minimum 1 ms).
Threshold Enter the threshold in bytes. The driver will forward received characters after
threshold bytes have been received.
USB Command Mode
Settings
Description
Mode When Command Mode is enabled, the Command Line Interface (CLI) is attached to
the USB Line. Command Mode can be enabled in a number of ways:
The Always choice immediately enables Command Mode for the USB Line.
The Use Serial String choice enables Command Mode when the Serial String is
read on the USB Line during boot time.
Disabled
Wait Time Enter the Wait Time in milliseconds. The specified time defines the amount of time
to wait during boot time for the Serial String. This timer starts right after the Signon
Message has been sent on the USB Line.