Owners manual

9: Administration
SGX 5150 IoT Device Gateway User Guide 92
To Configure HTTP Authentication
Using Web Manager
 To configure HTTP authentication, on the Administration page, click HTTP >
Authentication.
Using the CLI
 To enter the HTTP command level: enable > config > http
Using XML
 Include in your file: <configgroup name="http authentication uri">
Line
The SGX 5150 unit contains three RS232 serial port types. All lines use standard RS232/RS485
serial ports. All lines can be configured to operate in the following modes:
 RS232
 RS485 Full Duplex (also compatible with RS-422)
 RS485 Half Duplex, with and without termination impedance
 All serial settings such as Baud Rate, Parity, Data Bits, etc, apply to this line.
The line settings allow configuration of the serial line.
Note: The following section describes the steps to view and configure Line 1 settings;
these steps apply to other line instances of the device.
Line Status and Configuration
View-only status information on the Line 1 - Statistics page displays line statistics including
information on bytes, queued bytes, breaks, flow control, parity errors, framing errors, overrun
errors, no Rx buffer errors, CTS input, RTS output, DSR input, and DTR output.
See Table 9-23 for the line settings that can be modified on the Line 1 - Configuration page. See
Table 9-24 for the line settings that can be established on the Line 1 - Command Mode page.
Table 9-23 Line Configuration Settings
Delete Click to delete the existing configuration.
Line Settings Description
Name Enter a name or short description for the line, if desired. By default, there is no name
specified. A name that contains white space must be quoted.
Interface One interface type is available per line:
 RS232 (available for lines 1 and 2)
 USB-CDC-ACM (available for line 3)
State Select to enable or disable the operational state of the Line. The default is Enabled.
HTTP Authentication
Settings
Description