Owners manual

9: Administration
SGX 5150 IoT Device Gateway User Guide 86
To Configure Gateway DHCP Server Settings
Using Web Manager
 To modify gateway DHCP server or static lease information, on the Administrations page,
click Gateway > Configuration > DHCP Server.
Using the CLI
 To enter the gateway command level: enable > config > gateway > dhcp server
Using XML
 Include in your file: <configgroup name = "dhcp server">
Static Lease Listing
The device also provides the ability to pre-assign specific IP addresses to connected devices
using static leases. This would ensure that the connected device (identified by the MAC address)
always gets the same IP address even while using DHCP.
Table 9-15 Static Lease Listing
Table 9-16 Add a Static Lease
Routing Protocols
The SGX 5150 IoT device gateway allows the configuration of routing protocols. Routing protocols
specify how routers communicate with each other, disseminating information that enables the
selection of routes between any two nodes on a computer network. Routing algorithms determine
the specific choice of route. Each router has a prior knowledge of networks directly attached to it. A
routing protocol shares this information among immediate neighbors first, then through the
network. This way, routers gain knowledge of the topology of the network. The SGX 5150device
supports RIP and OSPF protocols.
Static Lease List Settings Description
Delete Click checkbox beside existing static lease MAC Address/IP Address to
delete, if available and if desired.
MAC Address MAC Address of existing static leases are listed here.
IP Address Static IP Address of existing static leases are listed here.
IPv6 Address Static IPv6 Address of existing static leases are listed here.
Add a Static Lease
Settings
Description
MAC Address Enter the MAC Address of the static lease to be added.
IP Address Enter static IP address of the static lease to be added.
IPv6 Address Enter static IPv6 address of the static lease to be added.