Owners manual

9: Administration

SGX 5150 IoT Device Gateway User Guide 85

Table 9-13 Adding a New Static Route

To Configure Gateway Static Route Settings

Using Web Manager

 To modify gateway static route information, on the Administrations page, click Gateway >

Configuration > Static Routes.

Using the CLI

 To enter the gateway command level: enable > config > gateway > static route

Using XML

 Include in your file:

<configitem name="static

routes" instance="<number>"

DHCP Server

Allows the user to configure the device as a DHCP server.

Table 9-14 DHCP Settings

Adding New Static Route

Settings

Description

Name User friendly name for the route

Network Network or Host for the route

Gateway Gateway for the route

Interface Interface for the route

Metric Priority for the route. Lower metric means higher priority

DHCP Settings Description

State Enable or Disable the DHCP server for the DHCP settings.

 Enabled: DHCP server is enabled

 Disabled: DHCP server is disabled.

Lease time Duration for which lease is initially assigned. Clients must renew after this duration.

Start IP Address Start IP Address of address pool

End IP Address End IP Address of address pool

State Enable or Disable the DHCP server for the DHCPv6 settings.

 Enabled: DHCP server is enabled

 Disabled: DHCP server is disabled.

Start IPv6 Address Start IPv6 Address of address pool

End IPv6 Address End IPv6 Address of address pool