Owners manual

9: Administration
SGX 5150 IoT Device Gateway User Guide 75
To Configure Action Settings
Using Web Manager
 To view Action status, on the Administration page, click Action > Status on the menu.
 To modify Action information, on the Administration page, click Action > Configuration on
the menu and select a specific action from the drop-down menu. SMTP (on page 98) lists the
options.
Using the CLI
 To enter the eth0 link state change command level: enable > config > action > eth0
link state change
Email Use Email to send an email to configured Email recipients.
 If an Alarm Email profile number is selected, that email will be sent when the
alarm is turned on. The contents of Alarm Message will be placed into the email
body when an alarm email is sent. If the alarm stays on longer than the Reminder
Interval, another alarm email is sent.
 If a Normal Email profile number is selected, that email will be sent when the
alarm is turned off. The contents of Normal Message will be placed into the email
body when a normal email is sent. If the alarm stays off longer than the Reminder
Interval, another normal email is sent.
FTP Put Use FTP Put to put a file on configured FTP server.
Filename will be used to upload to remote FTP server. The IP Address or hostname
is the FTP server to connect. Port number is port on which FTP server is listening on.
Use Protocol to connect to FTP server. FTPS is a SSL encrypted communication
channel and SSL Trusted Authorities must be setup with FTP server SSL certificate.
Username is used to logon to FTP server. If FTP server does not require
authentication, use anonymous. Password is used to logon to FTP server. If FTP
server does not require authentication, a common practice is to use user’s email
address. If the alarm stays on or off longer than the Reminder Interval, another FTP
Put is performed. In Sequential Mode, connections will be attempted starting with
number 1 until a connection is successful. In Simultaneous Mode, all possible
connections will be made.
HTTP Post Use HTTP Post post to configured HTTP server.
The URL appears behind the HTTP server IP address or hostname. E.g.
http://
some_http_server/some_url
The IP Address or hostname is the HTTP
server to connect to. Port number is the port which HTTP server is listening on. Use
Protocol to connect to HTTP server. HTTPS is a SSL encrypted communication
channel and SSL Trusted Authorities must be setup with HTTP server SSL
certificate. Username used to logon to HTTP server if authentication is required.
Password used to logon to HTTP server if authentication is required. If the alarm
stays on or off longer than the Reminder Interval, another HTTP Post is performed.
In Sequential Mode, connections will be attempted starting with number 1 until a
connection is successful. In Simultaneous Mode, all possible connections will be
made.
SNMP Trap Use SNMP Trap to send SNMP trap to configured trap destinations.
The contents of Alarm Message are included when an alarm SNMP trap is sent. If
the alarm stays on longer than the Reminder Interval, another alarm SNMP Trap is
sent. The contents of Normal Message are included when a normal SNMP trap is
sent. If the alarm stays off longer than the Reminder Interval, another normal SNMP
Trap is sent.
Action Settings Description