Owners manual

6: Network Settings
SGX 5150 IoT Device Gateway User Guide 45
To Configure Network Interface Settings
Using Web Manager
 To view Ethernet (eth0) Interface statistics, on the Network page, select Wired Network >
Interface.
 To configure Ethernet (eth0) interface settings, on the Network page, select Wired Network >
Interface > Configuration.
Using the CLI
 To enter the command level: enable > config > if 1
Using XML
 Include in your file: <configgroup name= “interface" instance="eth0">
Link Status and Configuration
Table 6-4 displays the wired link status and configuration information. The view-only status
information is available on the Wired (eth0) Network Ethernet Link page. This same information is
configurable on the Wired (eth0) Network Ethernet Link Configuration page.
Table 6-4 Link (eth0) Configuration
Notes:
 When speed is Auto, duplex must be Auto or Half.
 When speed is not Auto, duplex must be Half or Full.
 Fixed-speed Full duplex produces errors when connected to Auto, due to duplex
mismatch.
IPv6 Primary DNS Enter the IP address of the primary domain name server.
Note: This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
IPv6 Secondary DNS Enter the IP address of the secondary domain name server.
Note: This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
Field/Button Description
Speed
Select the Ethernet link speed. (Default is Auto)
 Auto = Auto-negotiation of Link Speed
 10 Mbps = Force 10 Mbps
 100 Mbps = Force 100 Mbps
Duplex
Select the Ethernet link duplex mode. (Default is Auto)
 Auto = Auto-negotiation of Link Duplex
 Half = Force Half Duplex
 Full = Force Full Duplex
Field/Button Description