Owners manual

SGX 5150 IoT Device Gateway User Guide 40
6: Network Settings
Network settings for the SGX 5150 can be viewed and modified under the Network tab in the Web
Manager user interface. This chapter describes the following network settings:
 Access Point
 Bridge
 Wired (eth0) Network
 Wireless (wlan0) Network
 Wired (usb0) Network
 Protocol Stack
 VPN
 Wi-Fi Protected Setup
 WLAN Scan/QuickConnect
 WLAN Profiles
Access Point
Configure software-enabled access point interface on this page. Access point status information
displays at the bottom half of the page.
Table 6-1 Access Point Settings
To View or Configure Access Point Settings
Using Web Manager
 To view access point statistics and configuration options, on the Network page, click Access
Point.
Using the CLI
 To enter the command level: enable > config > access point
Access Point Field Description
State Select to enable or disable the access point. If enabled, the DHCP server
will assign IP addresses to the access point clients.
IP Address Enter the IP address of the SoftAP interface.
Network Name (SSID) Specify the network name/SSID of the access point. The SSID update will
take effect after the device is rebooted.
Security Suite Select a security suite to be used with the access point.
Passphrase Enter a passphrase if WPA or WPA2 security suite is selected above.
Note: This field appears when WPA or WPA2 security suite is selected.
Show Password (check box) Check to make the passphrase entered to the left visible.
Note: This field appears when WPA or WPA2 security suite is selected.