Owners manual

9: Administration
SGX 5150 IoT Device Gateway User Guide 125
Table 9-51 Bridge 1 (br0) Configuration
Table 9-52 Wi-Fi Protected Setup
Table 9-53 Current Configuration
Table 9-54 Available Networks
5. Click Clear at any time to clear all fields of choices made (if any). The Clear button will only
appear when changes have been made to fields above.
6. Click Manual Setup to return to the Status page where you may make changes directly in the
configuration pages accessible through the Network, Diagnostic and Administration tabs.
7. Click Submit to submit configuration choices on the Quick Setup page.
Setting Description
State Select to enable or disable the state
Transparent Mode Select to enable or disable the transparent mode.
Ethernet Interface Select the desired interface: eth0 or usb0
Bridging MAC Address Enter the bridging MAC address
Bridging IP Address Enter the bridging IP address
Auto Detect IPv4
Address
Check the radio button to enable it. If checked, the device will attempt to learn the
IP Address by using the source or destination IP address of packets arriving on
the Ethernet interface. This may affect the performance of running processes
during the learning phase.
Bridging IP Address Select to enable or disable autodetection of the IPv4 address.
Bridging IPv6 Address Enter the bridging IPv6 address
Setting Description
WPS (PBC) Click this button for push button connect.
WPS (PIN) Click this button for pin hole connect.
Setting Description
Network Name (SSID) View existing network name/SSID, if any.
State Select to enable or disable the state
IPv4 State Select to enable or disable the state
DHCP Client Select to turn on or off
IPv6 State Select to enable or disable the state
IPv6 DHCP Client Select to turn on or off
IPv6 Auto
Configuration
Select to turn on or off
Setting Description
Refresh scan results
every 60 seconds
Check this checkbox and click Scan to scan available networks every 60 seconds.
Scroll through list of available networks listed, as desired.