Owners manual

9: Administration
SGX 5150 IoT Device Gateway User Guide 108
System
The SGX 5150 settings allow for rebooting the device, restoring factory defaults, uploading new
firmware and updating a system’s short and long name.
Note: Anytime you reboot the unit, this operation will take some time to complete.
Please wait a minimum of 10-20 seconds after rebooting the unit before attempting to
make any subsequent connections.
Table 9-40 System Settings
System Settings Description
State Select to enable or disable the reboot schedule.
Warning: Use extreme caution when using scheduled reboots. The
device will automatically reboot as scheduled. Any configuration
changes not saved to flash memory will be lost. CLI/WEB sessions and
network traffic will be interrupted. To avoid frequent reboots, device will
not be rebooted if it was started or configured less than 30 minutes from
the current date/time.
Schedule Select the reboot schedule interval: Daily or Interval
Time (24 hour) Set the time to reboot by selecting the Hour and Min (Minute) in the drop-
down menus.
Note: This configuration option appears when the Daily schedule is selected.
Interval Enter the interval number in the field. Then select the type of interval from the
drop-down menu:
 Hours
 Days
 Weeks
 Months
Note: This configuration option appears when the Interval schedule is
selected.
Reboot Device Click the Reboot button to reboot the device. When the device is rebooted,
your browser should be refreshed and redirected to the main status page after
30 seconds.
Note: The redirect will not work as expected if the IP Address of the device
changes after reboot.
Restore Factory Defaults Click the Factory Defaults button to restore the device to the original factory
settings. All configuration will be lost. The SGX 5150 unit automatically reboots
upon setting back to the defaults. After setting the configuration back to the
factory defaults, the device will automatically be rebooted.
Upload New Firmware Click Browse... to browse to and select the firmware file. This process writes
the new firmware file to firmware.rom on the SGX 5150 unit. The device
automatically reboots upon the installation of new firmware. See the section
FTP on page 81.
Caution: Do not to power off or reset the device while uploading new
firmware. Once the upload has completed and the new firmware has
been verified and flashed to memory, the device will automatically be
rebooted.