User guide

10: Maintenance
SecureLinx Spider/SpiderDuo User Guide 93
3. Do one of the following:
a. Click Save to save settings.
b. Click Reset to Defaults to restore system defaults.
c. Click Reset to restore original settings.
Configuration
In the Configuration page, you can specify the backup, preserve Network Basic and VIP settings,
and restore the computer or Spider configuration.
To view the configuration parameters, perform the following steps.
1. Click Maintenance > Config/Factory Defaults. The following page displays.
Figure 10-3 Configuration Page
Connected Users
Displays the user name and IP address of the active connection. It also
displays whether the user is connected to the Remote Console, and if so,
whether exclusive access mode is activated.
System Identifier
 Check the box to turn the ID indicator on and off. Each Spider has an
orange LED that can be lit by remote control. By default the LED is off,
and when you lear the checkbox, the LED gets turned on.
USB Status Displays the USB speed, keyboard, mouse, and mass storage status.
Table 10-2 Device Status Settings (continued)
Field Description