User guide

7: Interfaces
SecureLinx Spider/SpiderDuo User Guide 68
b. To mount the image, click Set. Information about the image displays in the Virtual Media
Active Image section of the page and the CD icon displays on the remote console.
Figure 7-30 Virtual Media Active Page
3. If desired, in the Virtual Media Active Image section:
a. Click Reactivate if the remote console does not recognize the image.
b. Click Unset to remove the current image file. This option is available only when a user
uploads a floppy image.
c. Click Download to save the image file.
Floppy Image
In the Floppy Image Upload section, you can upload a floppy disk image to the Spider, which
then appears to the attached computer as a physical floppy drive. The desired floppy image file will
be uploaded from the client system or from a network drive accessible to the client system. The file
must be structured as a floppy image. To make a floppy image, search for and use a utility such as
dd or rawwrite. The maximum image size is 1.44 MB. For larger images, use the CD-ROM Image
function.
The image file remains in Spider until the current user logs out, or the Spider is rebooted. Other
client systems logging into the Spider will also see the active image in all Virtual Media pages.
To upload a floppy image file, perform the following steps.
1. In the Floppy Image Upload section (bottom right), click Browse to locate the floppy image
file.
2. Do one of the following:
a. Click Reset to discard your changes.