User guide

4: Installing the SpiderDuo
SecureLinx Spider/SpiderDuo User Guide 35
5. Upon bootup, the terminal window displays the IP Configuration screen. At the command
prompt type config and press Enter.
Figure 4-4 SpiderDuo Welcome Screen
6. To change the default IP auto configuration from DHCP to a static IP address, at the IP
autoconfiguration prompt type none and press Enter.
Figure 4-5 SpiderDuo Default IP Configuration Screen
7. Follow the prompts to enter the IP address, subnet mask, default gateway, and LAN interface
information.
8. Type Enter, to accept the changes. The system takes about 20 seconds to complete. Type
Enter once again at the prompt to display the updated IP address.
9. Plug an Ethernet cable connected to your network into the Ethernet port. The Link LED
illuminates.
Note: To reboot or reset the SpiderDuo, press the reset switch through the pinhole on
the bottom of the device. You can also use the user interface or serial port.
10. Test the system installation (PC, local keyboard and mouse, video, and SpiderDuo) by
completing the following:
a. Turn off the power to the PC and SpiderDuo.
b. Reconnect all devices.
c. Turn on the SpiderDuo first, and wait for it to boot completely (the SysOK LED will be on
steady).
d. Turn on the PC.
SysOK
Blue On - Powered up and OK
Blinking - Booting
PCU
Green
On - Power Unit Connected ,
AC power is passed through
Table 4-3 SpiderDuo Indicator LEDs (continued)
Label Color Action