User guide

3: Getting Started
SDS1101/2101 User Guide 22
2. To enter Setup Mode, cycle the unit's power (power off and back on). After
power-up, the self-test begins and the red Diagnostic LED starts blinking. You
have one second to enter three lowercase x characters.
Note: The easiest way to enter Setup Mode is to hold down the x key at
the terminal (or emulation) while powering up the unit.
3. Select 0 (Server Configuration) and follow the prompts until you get to
IP address.
4. Enter the new IP address, subnet mask, and gateway (if applicable).
5. Do one of the following:
 Continue with 5: Configuration via Telnet or Serial Port (Setup Mode).
 Select 9 to save and exit Setup Mode. The unit performs a power reset.