User Manual

Additional Remote Networking Bandwidth On Demand
5-8
5.3.4 Displaying Current Bandwidth Settings
To display a site’s current bandwidth settings, use the List Site Bandwidth command.
Figure 5-13: Current Bandwidth Settings
To display how the SCS is currently managing a particular site’s use of bandwidth, use the Show Site
Bandwidth command.
5.3.5 Restoring Default Bandwidth Settings
To return a site’s bandwidth parameters to their default values, use the following command:
Figure 5-14: Restoring Default Bandwidth Values
5.3.6 Monitoring Bandwidth Utilization
The Show/Monitor Site command is particularly useful when allotting bandwidth to a site. Periodically
monitoring a site’s use of bandwidth will enable you to determine if the bandwidth configuration is
appropriate and to make adjustments when necessary.
Figure 5-15: Displaying Bandwidth Utilization
Note: For information on port and site states, see Table 4-3 on page 4-19.
Local>> LIST SITE irvine BANDWIDTH
SCS Version 1.1/101 Name: SCS_0C0021
Hardware Addr: 00-80-a3-0c-00-21 Uptime: 1 Day 02:56
Site Name: irvine Period: 60
Add @ Utilization: Disabled Remove @ Disabled
Maximum Bandwidth: 100 Initial Bandwidth: 100
Multilink: Disabled Hold Down Timer: 01:00
Input Utilization: 0% Output Utilization: 0%
Next Adjust Up: Any Time Next Adjust Down: Any Time
Target Bandwidth: 0 Waiting Bandwidth: 0
On-line Bandwidth: 0
Average Period -- Input -- -- Output -- - Dropped -
(in seconds) Bytes/Second Bytes/Second Bytes/Second
Size Total: 4 0 0 0
Size Total: 60 0 0 0
Local>> DEFINE SITE irvine BANDWIDTH DEFAULT
Local>> SHOW SITE irvine BANDWIDTH