User Manual

Basic Remote Networking Managing Connections With Sites
4-4
4.2.2 Displaying Existing Sites
To display all defined sites, use the List Site command. To display currently active sites, use the Show Site
command.
To display specific information about sites, the following parameters may be used in conjunction with Show
Site and List Site: IP, Ports, Counters, and Status. For example, to display the IP configuration of site
irvine, use the following command:
Figure 4-5: Displaying a Site’s IP Configuration
Note: The List Site command is used in Figure 4-5 because site irvine isn’t currently
running.
4.2.3 Editing Sites
All site characteristics can be edited with the Define Site commands. For example, a site’s authentication
can be edited with the command below.
Figure 4-6: Editing Site Characteristics
IP packet forwarding Enabled
Maximum idle time 10:00 (10 minutes)
Remote host’s IP configuration Undefined
IP compression slots 16
Maximum packet size (MTU): PPP 1522
Ports defined None
PPP Enabled
SLIP Disabled
Telephone number of remote site None defined
Outgoing packet filter None defined
Incoming packet filter None defined
Idle time filter None defined
Startup filter None defined
Maximum packet size (MTU): SLIP 1500
Maximum session time Disabled
Local>> LIST SITE IRVINE IP
Local>> DEFINE SITE irvine AUTHENTICATION PAP DISABLED
Table 4-1: Default Site Configuration
Characteristic Configuration in Default Site