User Manual

Command Reference Security Commands
12-178
12.11.21 Set/Define SNMP
Configures a community name and access mode for SNMP access. Each name has an access restriction
associated with it; if an SNMP command comes in with an unknown name or an unauthorized command,
an SNMP error reply will be sent. Community names are not case-sensitive.
Restrictions You must be the privileged user to use this command.
Parameters community
A text name, up to 16 characters long.
Access
Specifies the type of SNMP access. Must be used in conjunction with one of
the following parameters: Both, None, or Readonly.
Both
Both read and write requests will be permitted.
None
No SNMP requests are permitted.
Read
Read-only access will be permitted.
Examples
Local>> SET SNMP COMMUNITY SUNMAN ACCESS BOTH
See Also Clear/Purge SNMP, page 12-154; Appendix C, SNMP Support
12.11.22 Show/Monitor/List Authentication
Displays the local authentication database.
Restrictions Requires privileged user status.
Parameters username
Displays authentication information for the specified user.
Examples
Local>> SHOW AUTHENTICATION USER “bob”
See Also Set/Define Authentication, page 12-155; Local (NVR) Database, page 11-9
SET
DEFINE



SNMP COMMUNITY community ACCESS
BOTH
NONE
READ





SHOW
MONITOR
LIST





AUTHENTICATION
USERS
username