User Manual
Command Reference Site Commands
12-146
Note: A port must be defined before the Bandwidth, BytesPerSecond, and Telephone
parameters can be used.
Bandwidth
Gives the SCS a bandwidth estimate for the device (for example, a modem)
that is attached to the port. Must be used in conjunction with the
BytesPerSecond parameter.
Note: See Estimate Each Port’s Bandwidth on page 5-6 for more information on how
to use the port bandwidth setting.
BytesPerSecond
The bandwidth value. The value can range from 100 to 6,550,000 bytes per
second.
Telephone
Specifies a telephone number for this port. This number will override the
number defined for the site as a whole. Must be used in conjunction with either
the number parameter or the None parameter.
number
A telephone “number” of up to 24 characters (characters can be of any type).
None
No specific telephone number will be set for this port.
Priority
Specifies a priority level for a particular port. Higher priority ports will be
dialed before ports with lower priority numbers. Must be used with the
prioritynum parameter.
priorityNum
An integer between 1 and 100 representing the priority level of the specified
port.
Defaults Bandwidth: 100 bytes per second
Examples
Local>> DEFINE SITE irvine PORT 2 TELEPHONE “8675309”
Local>> DEFINE SITE irvine PORT 2 BANDWIDTH 28800
See Also Define Site Bandwidth, page 12-136; Show/Monitor/List Sites, page 12-151;
How Bandwidth is Controlled, page 5-5
12.10.11 Define Site Protocol
Defines the “line” or “link layer” protocol that this site should use for outgoing calls. Reset the Maximum
Transmission Unit (MTU) value to the default PPP or SLIP MTU value.
DEFINE SITE SiteName PROTOCOL
PPP
SLIP