User Manual

Command Reference Server Commands
12-127
12.9.22 Set/Define Server Rlogin
Restricts the use of the Rlogin command from the server. If Rlogins are disabled, you may not Rlogin to
remote hosts. Incoming Rlogin connections may still be permitted, depending on the current Set/Define
Server Incoming setting.
Restrictions Requires privileged user status.
Defaults Disabled
12.9.23 Set/Define Server Session Limit
Sets the limit on active sessions per port. Each port can have an additional limit less than or equal to this
limit.
Restrictions Requires privileged user status.
Parameters limit
A number between zero and 8.
None
The maximum possible session limit is used (8).
Defaults 4 sessions
See Also Port-Specific Session Configuration, page 8-4
12.9.24 Set/Define Server Silentboot
Causes the unit to attempt to boot without sending any status messages to the console port (unless there are
errors).
SET
DEFINE



SERVER RLOGIN
ENABLED
DISABLED



SET
DEFINE



SERVER SESSION
LIMIT
limit
NONE



SET
DEFINE



SERVER SILENTBOOT
ENABLED
DISABLED


