User Manual

Command Reference Service Commands
12-112
12.8.11 Set/Define Service PSConvert
Controls whether the SCS will place a PostScript wrapper around each job. The SCS will try to detect if it
is already a PostScript job, in which case it would not add an additional wrapper.
See Also Clear/Purge Service, page 12-107
12.8.12 Set/Define Service RTEL
Enables or disables RTEL access to the specified service.
Restrictions Requires privileged user status.
Defaults Enabled
See Also Clear/Purge Service, page 12-107
12.8.13 Set/Define Service SOJ
Specifies a string to be sent to the attached device at the start of every access regardless of network protocol.
Restrictions Requires privileged user status.
Parameters StartString
Any ASCII characters, or a backslash and two hex digits.
None
Clears any previously-configured string. No string is configured by default.
Examples
Local>> DEFINE SERVICE myserv SOJ \45
See Also Clear/Purge Service, page 12-107
SET
DEFINE



SERVICE ServiceName PSCONVERT
ENABLED
DISABLED



SET
DEFINE



SERVICE ServiceName RTEL
ENABLED
DISABLED



SET
DEFINE



SERVICE ServiceName SOJ
StartString
NONE


