User Manual

Command Reference Service Commands
12-111
12.8.9 Set/Define Service Ports
Specifies a list of ports that will support or offer this service. If Enabled or Disabled is specified, the ports
listed will be added to or removed from the current list, respectively. If neither option is specified, the new
port list will replace the old port list. Note that ports offering a service must be in the correct access mode
for connections to succeed.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
Examples
Local>> SET SERVICE lab5 PORTS 3,4,7-8 ENABLED
See Also Clear/Purge Service, page 12-107; Set/Define Ports Access, page 12-50
12.8.10 Set/Define Service Postscript
If enabled, the SCS will assume there is a PostScript printer attached to the service ports and will try to
ensure a job is done before starting another. It will send a Ctrl-D to the attached device and wait for the new
printer to return a Ctrl-D before starting the job transfer. If this is not done, slower printers may lose new
jobs while interpreting the previous job. Setting PostScript mode is strongly recommended for all PostScript
queues.
Restrictions Requires privileged user status.
Defaults Disabled
See Also Clear/Purge Service, page 12-107
SET
DEFINE



SERVICE ServiceName PORTS
PortList
ALL



ENABLED
DISABLED
SET
DEFINE



SERVICE ServiceName POSTSCRIPT
ENABLED
DISABLED


