User Manual

Command Reference Modem Commands
12-94
12.7.4 Define Ports Modem CallerID
Configures whether the SCS will look for and attempt to decode Caller-ID information for incoming calls.
The SCS should be set to wait for three rings before answering the line so that it has enough time to gather
the Caller-ID information. The ring setting can be configured with the Rings command.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
See Also Define Ports Modem Answer, page 12-92; Caller-ID, page 9-12
12.7.5 Define Ports Modem Carrierwait
Defines the length of time that a server will wait for a carrier on incoming and autodialed calls. If a carrier
is not received in that length of time, the SCS assumes that it will not be received. The call will fail and the
modem will be reset.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
seconds
A time value between 1 and 250 seconds.
Defaults 60 seconds
DEFINE PORTS
PortList
ALL
MODEM CALLERID
ENABLED
DISABLED



DEFINE PORTS
PortList
ALL
MODEM CARRIERWAIT ondssec