User Manual

Command Reference Port Commands
12-90
12.6.57 Show RS485
Displays the current RS-485 networking settings, including wire mode, termination, and TXDrive.
Restrictions Only applies to the SCS200.
See Also Define Protocols RS485, page 12-84; RS-485 Configuration, page 8-15
12.6.58 Show/Monitor Sessions
Displays information about the specified sessions.
Restrictions You must be the privileged user to use the Monitor command.
Secure users cannot specify Port or All.
Parameters PortNum
Specifies a particular port.
All
Displays the sessions currently running on all ports.
Examples
Local> SHOW SESSION
Local> SHOW SESSION PORT 5
See Also Set/Define Ports Security, page 12-76; Port-Specific Session Configuration,
page 8-4
12.6.59 Test Port
Tests a serial port’s connection by sending a continuous stream of ASCII alphabetic characters until the
number of lines specified by Count is reached. You can stop the test by pressing any key.
SHOW RS485
SHOW
MONITOR



SESSIONS
PORT PortNum
ALL
TEST PORT
PortNum
DTR
DELAY num
POSTSCRIPT
COUNT lines
WIDTH characters