User Manual

Command Reference Port Commands
12-83
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
username
A name of up to 16 characters in length, converted to all uppercase unless
enclosed in quotes.
None
Clears a current username.
Defaults None
See Also Specifying a Username, page 8-13
12.6.50 Set/Define Ports Verification
When enabled, the server will issue informational messages whenever a session is connected, disconnected,
or switched.
Restrictions Requires privileged user status if you wish to use this command on ports other
than your own.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Enabled
See Also Port-Specific Session Configuration, page 8-4
SET
DEFINE



PORTS
PortList
ALL
VERIFICATION
ENABLED
DISABLED


