User Manual

Command Reference Port Commands
12-81
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Enabled
See Also Padding Return Characters, page 8-13
12.6.47 Set/Define Ports TermType
Specifies a terminal type for the port. The terminal type is reported to the destination node in Telnet and
Rlogin sessions. Example terminal types might be VT100 or IBM1000.
Restrictions Requires privileged user status if you want to use this command on ports other
than your own.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
TermString
Enter a string of up to 8 characters in length.
None
Clears the field. There is no terminal type configured by default.
Defaults None defined
See Also Specifying a Terminal Type, page 8-13
SET
DEFINE



PORTS
PortList
ALL
TERMTYPE
TermString
NONE


