User Manual

Command Reference Port Commands
12-79
See Also Set/Define Ports SLIPdetect, page 12-79; Set SLIP, page 12-87; Show/
Monitor/List Ports SLIP, page 12-88; Starting PPP/Slip for Incoming
Connections, page 4-10
12.6.43 Set/Define Ports SLIPdetect
Automatically detects and starts running SLIP. Be aware that automatically running SLIP is a potential
security hazard.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
See Also Starting PPP or SLIP Using Automatic Protocol Detection, page 4-11
12.6.44 Set/Define Ports Speed
Specifies the baud rate of the port.
Restrictions Requires privileged user status if you want to use this command on ports other
than your own. Secure users may not use this command.
Errors An error is displayed for illegal baud rates.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
SET
DEFINE



PORTS
PortList
ALL
SLIPDETECT
ENABLED
DISABLED



SET
DEFINE



PORTS
PortList
ALL
SPEED speed