User Manual

Command Reference Port Commands
12-78
12.6.41 Set/Define Ports Signal Check
Determines whether or not the DSR signal will be checked for when remote connections to the port are
made. If enabled, remote connections to the port will not be permitted unless the DSR signal is asserted.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
See Also DSR for Controlling Remote Logins, page 8-22
12.6.42 Define Ports SLIP
The Enabled and Disabled parameters determine whether or not SLIP can be run on the specified port. The
Dedicated parameter devotes that port to SLIP mode.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Dedicated
The specified port will automatically run SLIP when it is started. No other
protocol can be run on the port; it will continue to run SLIP until it is logged
out.
Defaults Disabled
SET
DEFINE



PORTS
PortList
ALL
SIGNAL
CHECK
ENABLED
DISABLED



DEFINE PORTS
PortList
ALL
SLIP
ENABLED
DISABLED
DEDICATED




