User Manual

Command Reference Port Commands
12-76
12.6.38 Set/Define Ports Security
Setting a port to Secure status restricts its access to SCS commands and the ability to get information about
other ports using Show/List commands. Privileged commands are not available to secure users. Certain
other commands cannot be entered for a port other than the secure user’s own port.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
See Also Preferred/Dedicated Protocols & Hosts, page 8-7; Chapter 11, Security
12.6.39 Set/Define Ports Serial Log
Spools idle serial data to the RAM disk, where it is logged into a file that can be accessed later. The file will
be saved in the form “/ram/Port_xx.log” where xx is the port number. This command also indicates the
maximum size of the log file and changes the specified port to Access Remote.
If the file size reaches the limit set by this command, the file will be truncated to half its current size, and
will start logging again. The oldest data will be discarded.
To stop serial logging, enter 0 as the file size.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
SET
DEFINE



PORTS
PortList
ALL
SECURITY
ENABLED
DISABLED



SET
DEFINE



PORTS
PortList
ALL
SERIALLOG
LIMIT
number