User Manual

Command Reference Port Commands
12-70
Errors Autobaud will not work unless the port is using 8 bit characters, or 7 bit
characters with even parity.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults None (no parity)
See Also Set/Define Ports Autobaud, page 12-52; Set/Define Ports Character Size, page
12-57; Serial Port Configuration, page 8-12
12.6.33 Set/Define Ports Password
Controls whether or not the login password is required to log in to an SCS port. The Set/Define Server
Login Password command is used to set the password.
Restrictions Requires privileged user status.
Errors The virtual port (port 0) password must be enabled or disabled with the Define
command.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Incoming
When enabled, users who Telnet or SSH directly to the target serial port are
forced to provide the login password.
Defaults Disabled
See Also Set/Define Server Login Password, page 12-122; Login Password, page 8-10
SET
DEFINE



PORTS
PortList
ALL
PASSWORD
ENABLED
DISABLED
INCOMING
ENABLED
DISABLED













